Please complete the following configuration steps in the Trifacta® platform.
NOTE: Integration with ADLS Gen2 is supported only on Azure Databricks.
- You can apply this change through the Admin Settings Page (recommended) or
trifacta-conf.json. For more information, see Platform Configuration Methods.
Enable ADLS Gen2 as the base storage layer:
Parameter Description webapp.storageProtocol
Sets the base storage layer for the platform. Set this value to
NOTE: After this parameter has been saved, you cannot modify it. You must re-install the platform to change it.
hdfs.enabled For ADLS Gen2 access, set this value to
hdfs.protocolOverride For ADLS Gen2 access, this special parameter should be empty. It is ignored when the storage protocol is set to
Configure ADLS Gen2 access mode. The following parameter must be set to
Set the protocol whitelist and base URIs for ADLS Gen2:
Parameter Description fileStorage.whitelist
A comma-separated list of protocols that are permitted to read and write with ADLS Gen2 storage.
NOTE: The protocol identifier
"abfss"must be included in this list.
For each supported protocol, this param must contain a top-level path to the location where Trifacta platform files can be stored. These files include uploads, samples, and temporary storage used during job execution.
NOTE: A separate base URI is required for each supported protocol. You may only have one base URI for each protocol.
- Save your changes.
- The Java VFS service must be enabled for ADLS Gen2 access. For more information, see Configure Java VFS Service in the Configuration Guide.
This page has no comments.