...

1. Edit the following file:

   Code Block
   /opt/trifacta/pkg3p/tripache/conf/conf.d/trifacta.conf

2. Add values for your LDAP environment for the following settings. For an Active Directory configuration, remove the comment from the first Define line and specify appropriate values for the following:

   Code Block
   ################################################################################## # Basic : LDAP Configuration # # Active Directory Mode. Uncomment below to enable Active Directory compatibility # Define ACTIVE_DIRECTORY "1" Define TF_LDAP_SERVER "ldap://SERVER:PORT" Define TF_LDAP_BASE_DN "<BASE_DN>" Define TF_LDAP_BIND_DN "<BIND_DN>" Define TF_LDAP_BIND_PASSWORD "<BIND_PASSWORD>"

3. By default, SSO access occurs over port 2443. If needed, you can set the port number for user access in the following setting:

   Info
   NOTE: This value should not be set to any value that conflicts with other ports in use by the D s server . For more information, see Configure SSO for AD-LDAP.

   Code Block
   <VirtualHost *:2443>

   Info
   NOTE: To complete the configuration to change the listening port, additional configuration is required after you complete this section. Instructions are in the following section.

4. Save the file.

5. D s config
   method a

6. Set the following parameter:
   

   Code Block
   "webapp.sso.enable": true,

   
   

7. Create an admin account. You can either:

   1. Connect to the application using an AD-linked ID. The first AD account to connect to the application is auto-registered as an admin account.

   2. Define an admin user under SSO. For more information, see Create Admin Account.

8. Save your changes.

9. Save the file and restart the platform. See Start and Stop the Platform.

Change Listening Port for SSO

By default, SSO access uses port number 2443. If you need to change that listening port, please complete the following steps.

Steps:

1. If you have not done so already, in trifacta.conf, please set the VirtualHost value to the appropriate port number. See previous instructions.

2. Edit the following file:

   Code Block
   /opt/trifacta/pkg3p/tripache/conf/conf.d/httpd.conf

3. Locate the following entries:

   Code Block
   #Listen 12.34.56.78:80 Listen 2443

4. Change the value for 2443 to be the value you set in trifacta.conf. 

5. Save the file.

6. Perform any other necessary configuration before restarting the platform.

User Management

Configure auto-registration

...