Page tree

Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. Define S3 to be the base storage layer. See Set Base Storage Layer.
  2. Enable read access. See Enable read access.
  3. Specify a value for  aws.s3.bucket.name , which defines the S3 bucket where data is written. Do not include a protocol identifier. For example, if your bucket address is s3://MyOutputBucket, the value to specify is the following:

    Code Block
    MyOutputBucket
    Info

    NOTE: Specify the top-level bucket name only. There should not be any backslashes in your entry.

Info

NOTE: This bucket also appears as a read-access bucket if the specified S3 user has access.

...

  1. Specify the extraBuckets array as a comma-separated list of buckets as in the following: 

    Code Block
    "extraBuckets": ["MyExtraBucket01","MyExtraBucket02","MyExtraBucket03"]
    Info

    NOTE: Specify the top-level bucket name only. There should not be any backslashes in your entry.

  2. These values are mapped to the following bucket addresses:

    Code Block
    s3://MyExtraBucket01
    s3://MyExtraBucket02
    s3://MyExtraBucket03

...